Safe operating rules for wood cutting machines

　　Safe operating procedures for wood cutting machines are essential to ensure the safety of operators. The following are the detailed safety operation procedures:

　　Preparation work:

　　Ensure that the work area is clean and free of debris and obstructions.

　　Check that the power line, switch, and ground cable of the cutting machine are intact and connected reliably.

　　Check whether the saw blade and accessories of the cutting machine are installed firmly, without damage, no cracks, etc., if there is a problem, it should be replaced in time.

　　Wear appropriate protective gear such as overalls, gloves and goggles, and ensure that long hair and clothing do not get involved in the machine.

　　Check before operation:

　　Before starting the cutting machine, ensure that the saw blade is not in contact with the wood to avoid breakage or damage to the saw blade.

　　Check the starting switch, brake device, cutting edge and other key parts of the cutting machine to ensure that they are in normal working condition.

　　Operation process:

　　During the operation, the wood should be held with both hands to ensure that the wood is firm and does not slide. Do not use one hand or foot to hold down the wood.

　　Maintain concentration and avoid operating the cutting machine under fatigue, drinking or smoking.

　　When cutting, it is necessary to hold the handle of the cutting machine firmly, apply even force, cut vertically down, and avoid oblique cutting or twisted cutting.

　　Do not cut unclamped small workpieces or profiles with serious edges to avoid accidents.

　　If multiple branches are needed to cut together, auxiliary clamping positioning should be done to ensure stable cutting.

　　Do not perform strong sawing, should be operated after the motor speed reaches full speed.

　　During the cutting process, do not stand behind the saw blade to avoid being injured by flying wood or saw blade.

　　Do not operate if the shield is not properly installed. The hand should not be placed within 15 cm from the saw blade, and the body should be kept at a diagonal side of 45 degrees, and should not lean over or around the saw machine.

　　Midway maintenance:

　　If the cutting blade needs to be replaced midway, ensure that the lock nut is not tightened too hard to prevent the saw blade or the grinding wheel blade from cracking.

　　Before performing any maintenance or replacing parts, turn off the power supply and take appropriate protective measures.

　　Finish work:

　　When the cutting work is completed or you need to leave the working area, the power supply should be cut off immediately to ensure that the cutting machine stops running completely.

　　Clean wood chips and dust from work areas and cutting machines to keep equipment clean and tidy.

　　Daily maintenance and inspection:

　　Regularly check the cutting machine power line, transmission system, cutting edge and other parts of wear, and timely replacement of damaged parts.

　　Follow the operation instructions and maintenance suggestions in the equipment manual to keep the equipment in good running condition.

　　By following the above safe operating procedures, you can ensure the safe use of wood cutting machines and reduce the risk of accidents.

　　Rilyn-Our company is committed to creating a one-stop shopping solution for global woodworking machinery users, we have planer saw machine, wood router machine,wood laser cutting machine and other series of equipment.